Tuesday, November 2, 2010

Fence Project: O'Dea-O'Dea

The Fence Project was put into motion as of Saturday, 30 October.  The first day consisted of rental of a gas auger and a manual post digger to accomplish the tasks of digging seven (7) 3' deep holes on my property line to place the seven (7) post.  Three foot holes were required, as I want the privacy fence to be at the maximum height allowed by the county of seven feet (7') high.

My next door neighbor's project only required two (2) post holes at 2' deep for his dog pen project that will have six foot (6') high fence ends sandwiched between the existing fence and their deck.

The second day consisted of not two (2), but (3) trips to Home Depot for supplies of wood, cement, hanger brackets and treated deck screws.

Sunday, prior to sundown, we had all of the post in the ground with cement setting.  Plus, all of the top rails of the privacy fence on my property were cut and installed, as well as the middle and lower rails of one section for me to use as a sample to finish the remainder of the project on my own.

Another Friday Re-Build purchase included solid cedar, decorative post caps.  They truly make a difference on the finished appearance of the post.  I am now pondering as to whether or not the linear foot cost of use of a decorative rail top to the fence would be cost prohibitive or not. 
Cedar Post Cap

Might look much more finished and professional than the plain, straight top board finish.  But, the jury is still out on budget ($).

I will post photos later.

Hallway Chandelier Replacement Project

Current, builder's original, single lamp hall chandelier
Replacement, multi-lamp chandelier
Another story of me not getting out of Re-Build "
alive". 

The original, builder's chandelier in the entryway is the only overhead light in the living area and with one lamp barely provides much in terms of illumination.  Plus, it is dull and pretty chintzy in appearance and construction, as is the dining chandelier.

The Re-Build Representatives response to my inquiry as to the cost of the heavy, large colonial glass chandelier  price was "Would you be taking it with you now or coming back for it later?"

It cost me $40 to take it with me Friday PM, along with my load of slate patio pavers. 

Though the chandelier road shot gun in the cab protected with a heavy packing blanket to provide safe passage home.

This is a future project and will require some additional length of brass chain, clear electrical wiring and copper ground wire prior to installation.

Library Project Materials Selections: Stove, Drapes, Tile & Upholstry

Selections of some of the materials for the Library Project:

To include Vermont Castings, Radiance gas burning stove in enamel biscuit color with addition of warming racks and mitten dryer hooks.


Vermont Castings Radiance Gas Stove - on floor @ Re-Build
 Mount Vernon style pattern toile cotton drapes with silk plaid print accent boarder and lining shown below along with Daltile, 12"x12" smaller neutral shaded tile shown on right.  Fabric upholstery of chairs is a matching blue, as is the blue leather, older Chesterfield sofa.

Drapes, chair upholstery and tile (selected more neutral small tile)


Color is truer in this photo for tile and drapes





Sample of base cabinets
 Paint, to-be-determined: 
More than likely selection will also be somewhat neutral and due to the fact that the basement room in question only has two basement sized windows, a lighter shade will be selected.

Library Project at O'Dea-O'Dea

It was a jam packed weekend, as I was working with my neighbor Saturday and Sunday on the fence project for our property line.  Plus, I went into Re-Build Friday PM to begin the process of picking up the two pallets of large slate paving stones and hauling them home in my truck, etc.

Once again, I did not get out alive, so to speak.  But, I count this as a good thing, as I do believe that I finally have the cabinet and shelving components to re-do the main man cave, a.k.a. the basement library. 


View of custom built library prior to being removed from private residence


The procurement consists of 11 pieces and most are shown above. 

I also purchased two very large, three drawer matching custom units that are larger than commercially made file cabinets.

My current estimate is that the top shelving units are approx. 15" too high for the less than 8' floor to ceiling height in the basement.  But, I am optimistic, that as these were custom built, that there should not be any issues reducing the height by removing some of the top and a little more from the bottom of each shelving unit. (note, top crown moulding was not included.)

One very tall shelving unit will be placed upstairs in the front of the living room (not shown).  It is 8'10" and roughly 32" wide.  The only space that it can occupy in the house is the front room, as it is sunken and has a vaulted ceiling that extends to the roof.

Actually, in terms of scale, I believe this will be a welcome addition, as the walls are very high in this room and yet I do not have any items that are tall within the space.

From the same Great Falls estate, that is being dismantled, Re-Build had a Vermont Castings, Radiance gas stove in enamel biscuit and included the added side warming shelves.  This I purchased as the basement is cool or cold year round, in spite of central air and it only makes sense to heat the space during cold months as needed.


Vermont Castings Radiance Gas Stove with Warming Shelves

It is going to be one difficult project given the amount of "stuff" in the basement and the fact that all of the carpet has to be removed and flooring replaced.  Plus, the walls will require cleaning and painting.  This is just the tip of the iceberg, I am sure.

Rough dimensions of the space are 25' x 16' for the main section and at the base of the stairs the hallway area is approx. 5'x6'.  Translation a heck of a lot of flooring material will be required for this project.  Thus, I quickly made the determination to go with a Daltile porcelain tile in neutral colors that Home Depot currently has on special for 77 cents per square foot, as I estimate that this project will require at least 380 square feet of material.

I already have a blue, leather Chesterfield sofa that I have had for years that will be moved down stairs once the room is completed, as well as two new sets of cotton toile custom drapes that are full length.

Recent purchase of the two antique arm chairs manufactured in Cambridge, MA will make residence along with the sofa.

Stay tuned as the project gets underway and the man cave and library  is transformed into the catwoman cave and library.

MeOw!

Latest Editions to My Library & Gifts to Others

I purchased the following two books:

Gifts from my sister to me:
Gifts to my cat lady neighbor, who cared for the fur children while I was away for an extended weekend trip up north: